Not running on its own.

[sjturbonuk]

I just pick up at 85 daytona with alittle work done to it. You have to keep hiting the gas to keep it running. It has a intercooler with hard pipes. What I want to know is it not staying running because I bypassed the Masi Calibration.

[NAJ]

I would like to try to help but I am not into performance mods and do not know what a "Masi Calibration" is.
Did the vehicle idle fine before it was bypassed?
Regardless, Idle is dependant on throttle plate opening and AIS position.
Where in Jersey are you located, not a lot of TDer's from Jersey.

[sjturbonuk]

The guy before me did the performance mods. From what I know it was running fine before.

[NAJ]

But what is a "Masi Calibration?"

[sjturbonuk]

most people call it cal on here. I dont know anything about this car but I'm sure air has to pass through it as to where mine dont like the 1st pic.

[sjturbonuk]

Also I live in Egg Harbor Township near Atlantic City.

[NAJ]

Another TDer from S.J. Cool!!!!!
I am in Lindenwold, my sister lives in O.C.
The air flow thru the controller is to "cool" the electronics internally, probably not causing your stalling problem.
Start with basics, check base idle and reset AIS position.
The entire procedure is listed in a "Sticky" in the "Help" section titled "Help with Poor Idle".

[sjturbonuk]

ok i'll try that.

[NAJ]

Also since you just got the car and are unsure of what was done you may want to verify that Cam and Ignition timing are correct.

[sjturbonuk]

OK pulled codes today and I got 12,23,24,and 33. I can see having 12 cause I unhook the battery when I'm not fixing it. Also 23 I fix that I didnt have a plug for the sensor. After fixing 23 it idles high. That is better than no idle at all. I think that was causing all the gas in the oil. I just need to fix 24 for the throttle position sensor. I dont know what to do about 33 because I dont have a/c any more so what to I do about the relay code.

[NAJ]

The A/C code should not affect driveability or turn the light on, it will just be a code that will always be in memory.