How much HP can I get out of my setup?

[Turbo_zo]

I was wondering what WHP numbers can I see from my set-up. I want 350WHP or more.....This my set up:

*VentedCB with stock 2.5 crank
*JE .040"over pistons
*Eagle Rods
*Clevite Race Bearings (rods and mains)
*ARP Main studs
*Stock head
*High volume oil pump
*Copper sprayed cometic head gasket
*Turbonetics T3/T4 50trim T04e with .48A/R exhaust housing
*Supra Intercooler (front mounted)
*2.5" intercooler piping
*stock throttle body :-(
*stock one piece intake manifold
*3"swing valve
*2.5" down pipe with 3" exhaust after that (no CAT or muffler
*AFPR
*52lb/hr injectors
*Stage 5 CAL from FWDP
*3-Bar MAP sensor
*255 Walboro fuel pump

I'm probably leaving something out, but this is my set-up for the most part and it runs damn good. Just wanna know what WHP I should be expecting. I plan on running 24-26psi at the track/dyno.....Honost opinions on HP levels Thanks ALOT,
Lorenzo

[tryingbe]

You probably won't get more than 270hp with that .48 turbine housing.

[Turbo_zo]

Quote:

Originally Posted by tryingbe You probably won't get more than 270hp with that .48 turbine housing.

really??? even at like 25psi?........so I should upgrade to a .63a/r housing? If with that what am I looking at then?