boost controller install

[86shelby15psi]

where is the best place to put it 86s/c

[Phreakish]

well... I took out the black plastic 'can' ontop of the intake manifold, put in a 3/8" to 1/4" pipe thread bushing, put in a 1/4*close NPT nipple. Put a brass 1/4NPT TEE on there, and a 90* 1/2" nipple to 1/4" NPT nipple on THAT to put the 4-into-1 connector on, then on the other end of the TEE I threaded in the Grainger, and installed a brass nipple on the end of it, and sent that straight to the wastegate...

I put a TEE in the wastegate line with a .030" vac orifice bleed, and it works great. I have an '85 SC.

[OmniGuy123]

If you have a grainger valve, I would simply cut the line going to the WG , and pulug the grainger valve in. Make sure that pressure will be pressing directly against the ball, so it can unseat. If you install it backwards no pressure will be able to get through, as it will just press the ball fast against the seat.

Also check out the www.thedodgegarage.com as it certianly has the proper way to hook it up on there.