cylinder taper wear limit

[eyeball]

I've got a nice commonblock that I was thinking of just honing and dropping some new rings in. Cylinder taper is 0.0010 - 0.0015 on all four cylinders. Is this in spec? It's a 16v engine, and I don't want to have to bore it and buy new forged pistons if I don't have to.

Thanks,

[altered7151]

Bore taper limit is .005". Put some rings in her and haul ass"thumbs up

[eyeball]

Quote:

Originally posted by altered7151 Bore taper limit is .005". Put some rings in her and haul ass"thumbs up

Will do! :big grin: