Stage 5 wont run

[necromancer]

Switched from 87 GLHS module to the Stage5 ((87 t2) electronics. I checked and double checked the wires that needed to be moved etc..With the 3 bar it just sputters then dies. If I plug in the 2-bar itll run decent but for just 10-11 seconds then shuts down, but itll restart then shut down 10-11 seconds. Could my brand new 3bar be bad. I bought it on ebay as a kit, brand new??
Anyone got any ideas??

[Sittn86]

Are you running the S5 with 3-bar MAP & +40% injectors? Is the MAP sensor wired properly? What are you switching when it runs longer? More specifics are needed.

[charger R/T]

which 3 bar map sensor are you using? There were some threads a while ago about 2 differant numbered GM sensors that needed wired differant.
here is a link out of the old thread about the wiring Gm Map Sensor Wiring.. HERE IT IS!!!
and the thread it came from know your 3bar
Tim

[gkcooper]

Will it run WITHOUT the MAP sensor attached?

[necromancer]

No go. Map sensor only has these light colored numbers on it
1007h23. Itll run without the sensor and a very low idle and you can even touch the gas pedal. I swapped grnd and 5v but it made it even worse. Im sure I wired it right but I supose Ill triple check them wires.

[crazymadbastard]

check the output make sure it is sending out 1.60ish with the key on and the engine off and the hose unplugged. I have some issues with my 3 bar also.

[necromancer]

Will certainly check on it tomorrow...thx

[necromancer]

The output voltage was 1.62ish..ugh!!!! What would u suggest now. I picked the Stage5 up from a board member so...???...I have a eprom programmer but after I load a program it doesnt act right, the power loss lamp comes on kinda half ass etc..Do I need to do a offest when I a progm it?/

[necromancer]

BTW I sent the module to CIndy to ensure I have a good working Module, We'll see.