TD New Guy
Join Date: Apr 2017
Thanked 0 Times in 0 Posts
89 CB build parts for sale
I started doing a full rebuild on my 89 Daytona Shelby years ago and never finished it. So now im selling all of it. All prices are best offer, worst thing I can say is no. Here’s the parts list (I will be adding as I go thru boxes). Shipping is not included in price. And from some reason i cant put pics on here, if you want a pic let me know or until i figure out the picture thing.
2.2 CB short block bored .020 for pistons, ARP main stud kit installed and torqued for main caps, mainline needs to be machined because of stud install-$250 hemi orange!
2.2 CB crankshaft polished
Swirl head- 3 angle valve job, port and polished(mild/moderately) machined for +1mm on intake and exhaust valves. Valve seats were cracked, but had them repaired. $125 can throw in the valves, PT lifters(mopar), valves +1mm(from FWD perf.), valve keepers intake/exhuast(mopar), GM LS valve spring retainer, stock cam 250$
Intake bolt kit 15
Rod bearings(two sets)- .25mm clevitte 77 and .25mm enginetech 15 each
Main cap bolts -20
Intake/exhaust gasket mopar-8
Intermediate shaft bearing kit-11
180 degree thermostat with small hole drilled in it(used but works great)3
3” downpipe for 89 daytona-70
Magnecore 8mm spark plug wires used but in good cond. Set is missing coil wire.-25
2.5 garret swingvalve good condition 75
Turbonetics 50 trim(I believe) with stage 1 turbonetics turbine house .63 AR Without swing valve has large waste gate can Chrysler flange on turbine housing
No in and out shaft play, minor up and down play. Can part turbine housing for 125 other wise 275
89 daytona front driver side fender in great shape-75
89 daytona front bumper with no ground/fx in great shape 100
Sold items-flywheel, flywheel bolts, head gasket, head bolts, pistons, rods, polybushings(2), intermediate shafts,
Last edited by Andparker87; 04-23-2017 at 08:58 AM.