USA 568 trans manual with obx

[pzito1]

I have a new trans never in the car my motor blew before I could of put this in. Cliff Ramsdell built this 568 with posi , with drain plug And obx,, 17 spine
location in mountain top,pa. (570)956-1961 $750.00. I also have a half shaft poly bushing and a metal bobble that's extra.i have pictures email me or text
Me and I will send photos.

[xtrempickup]

id be interested, what is the final drive in it?

[signsoflife22]

Quote:

Originally Posted by pzito1 I have a new trans never in the car my motor blew before I could of put this in. Cliff Ramsdell built this 568 with posi , with drain plug And obx,, location in mountain top,pa. (570)956-1961 $750.00.

I live probably 10 miles from you!!
I called and left a message bro!

PM Sent also.

[pzito1]

Quote:

Originally Posted by signsoflife22 I live probably 10 miles from you!! I called and left a message bro! PM Sent also.

I didn't get any message call again

[pzito1]

Quote:

Originally Posted by xtrempickup id be interested, what is the final drive in it?

I don't remember sorry.

[xtrempickup]

i have cash and will be out there on saturday if its a 3.85 large spline

[pzito1]

Quote:

Originally Posted by xtrempickup i have cash and will be out there on saturday if its a 3.85 large spline

I'm sure it's large cause I had a 523 tranny

[capev86]

should be a 3.50 (or possibly 3.77?) if it has an obx. the obx is the same as the neon quiafe so doesn't fit the bad boy trans unless it is turned into a hybrid.

[Lotashelbys]

Quote:

Originally Posted by capev86 should be a 3.50 (or possibly 3.77?) if it has an obx. the obx is the same as the neon quiafe so doesn't fit the bad boy trans unless it is turned into a hybrid.

Actually it could be 350 or 377 or 385 depending on the year the ring and pinion were taken out of. Only way to tell is to count teeth if it was never recorded anywhere....

Nice price tho!

[xtrempickup]

its a 3.85 17 spline, he showed me pictures last night, does not have hole for crank sensor so i'm not purchasing it, rather not drill 2 holes in the bell housing

[pzito1]

Quote:

Originally Posted by xtrempickup its a 3.85 17 spline, he showed me pictures last night, does not have hole for crank sensor so i'm not purchasing it, rather not drill 2 holes in the bell housing

I think Clifford changed my gearing to a 3.50 or 3.77. When he was doing it he did say I'm changeing ur years as of 350 or 377 no idea. But I do recall him saying that.

[Lotashelbys]

Quote:

Originally Posted by xtrempickup its a 3.85 17 spline, he showed me pictures last night, does not have hole for crank sensor so i'm not purchasing it, rather not drill 2 holes in the bell housing

I have a crank sensor drill jig to do that if u want to to use it in a TIII. Works great and i have drilled at least 10 cases now.

[xtrempickup]

i really want a 3.85 ratio hybrid, not a 3.50 or 3.77, i have all the parts to do mine, if i could have just bought and threw in i would have sold off my 568, 523 and obx.