Daytona Piller pod

[canadiandaytona]

FYI (I don't know if this is common knowledge)

The 94-2001 acura integra a-piller pod fits fairly good in the Daytona.

[Fleckster]

I don't think it's common knowledge, but then again, why wouldn't you just use the Daytona gauge pod?

[canadiandaytona]

No credit card therefore cannot get online.
and No stores in canada carry or even know the Daytona Pod exists.

So you got to get by other ways

I'll post some pics once installed

Does the actual daytona pod go all the way to the roof, or only part way up?

[Fleckster]

They are made by Lotek. Go to www.gaugepods.com to see it. You can buy it through FWD Performance and I bet Cindy would ship it to you if you sent a money order. Try www.fwdperformance.com and see what they have for payment options.

[GLHNSLHT2]

Quote:

Originally posted by Fleckster They are made by Lotek. Go to www.gaugepods.com to see it. You can buy it through FWD Performance and I bet Cindy would ship it to you if you sent a money order. Try www.fwdperformance.com and see what they have for payment options.

I like my modded mustang pod better than the lotek piece. The guages point at me better.

[Turbinator]

Do you have a web link for you Mustang Pod?

[Turbinator]

Do you have a web link for you Mustang Pod?

[GLHNSLHT2]

Quote:

Originally posted by Turbinator Do you have a web link for you Mustang Pod?

Unfortunately all my pics are on a server who's net access is down for an undetermined amount of time. There is trimming required to the edges of it. Mostly on the side against the windshield. But i like how the gauges look directly at me where the tona pod I've seen points them up towards the roof a bit to much for me. And I have my enthusiast seat in it's highest position and I'm 6'0" tall so it's not like I'm some short person that can barely see over the wheel

[Turbinator]

What year Mustang pods did you you use then and where did you get them, since Lotek, Inc., wasn't your brand of choice?

[GLHNSLHT2]

Autometer for a 79-93 fox body stang. Got it from summit for $20.

[Turbinator]

I'm sure you are referring to the 2 1/16" diameter part # ATM-10100 for the double gauge pod then, correct? Did you have to trim the entire length against the glass or just a portion of it?

[Turbinator]

How did you secure this Mustang pod to the pilar? It appears as though the Mustang pod has a different pillar contour than the Lotek designed to fit the Daytona pillar. Was there any gaps and how did it look after install?

[canadiandaytona]

I should be installing my pod this weekend...Pics soon.

What does everyone use to paint them? I have the dark grey interior.

[glhsken]

left it black on DK gray trim

[T3Boosted4]

Quote:

Originally posted by glhsken left it black on DK gray trim

Same here it looks great