Turbo Dodge Forums : Turbo Dodge Forum for Turbo Mopars, Shelbys, Dodge Daytona, Dodge SRT-4, Chrysler PT Cruiser, Omni and more! - Search Results

Advanced Search
Showing results 1 to 25 of 182
Search took 0.03 seconds.
Search: Posts Made By: 2fast2dodge
Forum: Parts For Sale   10-07-2018, 03:11 PM
Replies: 1
Views: 235
Posted By 2fast2dodge
94 Spirit Flex fuel engine harness, ECU and fuel rail

Engine bay harness, SBEC and fuel rail,
I pulled this from a flex fuel Spirit some time ago for a MPI conversion. ...
Forum: Parts Wanted   09-30-2018, 10:09 AM
Replies: 1
  Transmission A543 case
Views: 125
Posted By 2fast2dodge
Re: A543 case

I have one
You can try to PM me, or email
[email protected]



Sent from my iPhone using Tapatalk
Forum: Electrical   09-30-2018, 10:07 AM
Replies: 12
Views: 368
Posted By 2fast2dodge
Re: '84 rampage no spark

Another issue I have run into is a loose or corroded connector at / near the Power module. Look for a two pin connector (think rad. fan connector).
This inline disconnect for the ignition pick up...
Forum: Transmission, Suspension, Brakes, Tires & Wheels   09-17-2018, 09:25 AM
Replies: 4
Views: 210
Posted By 2fast2dodge
Re: A525 - 8bolt crank and a Fidanza

NA clutch is smaller diameter overall.
I have owned many NA mopars
I recently installed a turbo flywheel and clutch into my 84 Carbíd 2.2L



Sent from my iPhone using Tapatalk
Forum: Turbo Dodge Help   09-17-2018, 09:22 AM
Replies: 8
Views: 238
Posted By 2fast2dodge
Re: Heater control valve on a '92

Those heater control valves are junk!
Iíve run w/o them and see virtually no difference with or without them.
And just a side note, just about every one I have removed, leaky or not, are...
Forum: Parts Wanted   09-17-2018, 09:17 AM
Replies: 5
Views: 222
Posted By 2fast2dodge
Re: Looking for fuel rail/FPR return line!!!

I think I have that piece,
Iíll check this week, but you can contact me
At
[email protected]


Sent from my iPhone using Tapatalk
Forum: Parts Wanted   09-17-2018, 09:14 AM
Replies: 4
Views: 190
Posted By 2fast2dodge
Re: 1982 Rampage clutch release lever

I have clutch release levers
If you are looking for the illustration #28
For an A525 I do have them
Email me [email protected]
Since my ability to PM has not worked for 2 months and no...
Forum: Parts Wanted   09-17-2018, 09:10 AM
Replies: 6
Views: 345
Posted By 2fast2dodge
Re: Wanted: Rampage Rear Storage Tray

I have a blue one


Sent from my iPhone using Tapatalk
Forum: Electrical   09-17-2018, 09:08 AM
Replies: 12
Views: 368
Posted By 2fast2dodge
Re: '84 rampage no spark

Hereís my Rampage!
Itís been 12 years since itís been on the road, and Iíve gone through every piece and part of this little trucklet
Once the headpipe gets welded, it will be ready to go!
...
Forum: Electrical   09-17-2018, 09:02 AM
Replies: 12
Views: 368
Posted By 2fast2dodge
Re: '84 rampage no spark

You can check the ignition primary circuit by jumping the HEP (Hall effect position switch) commonly referred to as a pick up switch, because it ďpicks upĒ the ignition pulse produced by the Spinning...
Forum: Parts Wanted   08-28-2018, 01:36 PM
Replies: 5
  Transmission A 520 ring and pinion
Views: 184
Posted By 2fast2dodge
Re: A 520 ring and pinion

Since I cannot PM on this site Iíll post my email here
[email protected]



Sent from my iPhone using Tapatalk
Forum: Electrical   08-28-2018, 01:32 PM
Replies: 14
Views: 425
Posted By 2fast2dodge
Re: Speedometer questions

And check the condition of the plastic pinion gear, after time the gears will actually wear away and can cause poor or no road speed generation


Sent from my iPhone using Tapatalk
Forum: Parts Wanted   08-28-2018, 01:02 PM
Replies: 6
Views: 248
Posted By 2fast2dodge
Re: WANTED: GOOD or rebuilt A-413 3 spd transmission

I sell these for $550
They are straight rebuilds, clutches, bands, bearings and seals.
I go through the valve bodyís and replace (separator plates, solenoid if reqíd)
Diff bearings are replaced...
Forum: Electrical   08-28-2018, 12:50 PM
Replies: 5
Views: 220
Posted By 2fast2dodge
Re: My 1987 GLHS

Have you replaced bulbs in the cluster recently?
Recheck the bulbs in there respective sockets, make sure the bulbs all connect to the correct surface pad, another issue could the the small voltage...
Forum: Electrical   08-28-2018, 12:46 PM
Replies: 14
Views: 425
Posted By 2fast2dodge
Re: Speedometer questions

I would just add that banging on the dash could be an indication that the dash cluster, printed circuit board or tach itself have a cracked or loose solder joint, or faulty connection.

If you do...
Forum: Parts Wanted   08-24-2018, 10:30 PM
Replies: 5
  Transmission A 520 ring and pinion
Views: 184
Posted By 2fast2dodge
Re: A 520 ring and pinion

Did you get you pinion shaft?


Sent from my iPhone using Tapatalk
Forum: Parts Wanted   08-24-2018, 10:26 PM
Replies: 6
Views: 248
Posted By 2fast2dodge
Re: WANTED: GOOD or rebuilt A-413 3 spd transmission

I have no less than 5 turbo transaxles rebuilt and sitting on the shelf. Problem is Iím on the other end of the country (Oregon) !


Sent from my iPhone using Tapatalk
Forum: Turbo Dodge Help   08-17-2018, 06:05 PM
Replies: 21
Views: 922
Posted By 2fast2dodge
Re: Fuel pump brand?

Lots of pumps start leaking between the pass thru and pump hoses burst and can seriously reduce volume


Sent from my iPhone using Tapatalk
Forum: Parts Wanted   08-17-2018, 06:00 PM
Replies: 12
Views: 535
Posted By 2fast2dodge
Re: 1988 2.5 Water Pump Housing

Ok I have bottom out and rear out,
The late model pump housing will work on any year, but be warned, you must use the late model smooth pull because the belt turns the pump reverse rotation- as the...
Forum: Parts Wanted   08-13-2018, 07:51 PM
Replies: 12
Views: 535
Posted By 2fast2dodge
Re: 1988 2.5 Water Pump Housing

I have both types of housing rear nipple outlet and bottom exit nipple
https://uploads.tapatalk-cdn.com/20180814/97adbbf9f42104126e91f36dbefe1080.jpg
Bottom exit is late , 2.2/2.5 reverse rotation...
Forum: Cars For Sale   08-13-2018, 07:44 PM
Replies: 4
Views: 171
Posted By 2fast2dodge
Re: Transaxle side mout

Sent 8/13
Tracking
9505-5141-7567-8225-0950-88
2 day priority


Sent from my iPhone using Tapatalk
Forum: Parts Wanted   08-13-2018, 07:42 PM
Replies: 4
Views: 169
Posted By 2fast2dodge
Re: WTB: Shifter Cable Bracket A520 4412662

9505-5141-7567-8225-0950-95
2day priority


Sent from my iPhone using Tapatalk
Forum: Parts Wanted   08-13-2018, 07:40 PM
Replies: 4
Views: 169
Posted By 2fast2dodge
Re: WTB: Shifter Cable Bracket A520 4412662

Sent 8/13


Sent from my iPhone using Tapatalk
Forum: Parts Wanted   08-13-2018, 07:39 PM
Replies: 2
  Engine Carb ISOLATOR
Views: 142
Posted By 2fast2dodge
Re: Carb ISOLATOR

I have a rubber one?


Sent from my iPhone using Tapatalk
Forum: Cars For Sale   08-12-2018, 11:55 PM
Replies: 4
Views: 171
Posted By 2fast2dodge
Re: Transaxle side mout

Trying to clear it, I have no saved messages but it keeps telling me my inbox is full


Sent from my iPhone using Tapatalk
Showing results 1 to 25 of 182

 
Forum Jump
 
For the best viewing experience please update your browser to Google Chrome