Turbo Dodge Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-4 of 4 Results
  1. Turbo III
    ok so this may be a dumb question!! so dont judge to harshly! my newly aquired spirit needs some new main & rod bearings.. but i am wondering is it possible to put new ones in with the engine still in the vehicle? and just drop the pan? or is this just non-sense..?
  2. Turbo III
    im getting ready to throw some mains & rod bearings into my spirit r/t ...but i was wondering ...i have a set from an 87 T2 tona, and was hoping they were the same bottom end? so i can just throw em in there ?... any one? :confused:
  3. Parts For Sale
    I had a new factory 2.2 turbo 1 short block that sat around and developed rust in cylinders,disassembled,sold block.Now I am selling the crankshaft,rods with pistons,rings,bearings.Mopar new old stock,standard pistons and crank.New parts that have never been run,Crank journals have white grease...
  4. Turbo Dodge Help
    Hello everyone... Recently I had to replace the rod bearings on my 1990 Dodge Daytona. I started the engine several times after putting everything back together and the engine sounded better than before. I even drove the car around the neighborhood at low speeds with no issue. The other day I...
1-4 of 4 Results