Turbo Dodge Forums banner
cam gear
1-4 of 4 Results
  1. Turbo Dodge Help
    Now I wanted to post this in the help section for a few reasons. I've been on this forum for quite some time and I haven't seen a 100% positive answer to this questions. I have read multiple threads that contradict one another. *note I plan on editing this thread and/or perhaps make this a...
  2. Engine - General, Exhaust & Induction
    Hello TD, I need to remove my cam gear and install an offset key. Stock centerline = 106 degrees, .460 mopar purple cam =110 degree center. I added a 4 degree cam key, but do I insert it with the offset portion to the right or left in order to advance the centerline? Also, for removing the cam...
  3. Turbo Dodge Help
    I installed a 2.2 t2 motor in my aries with solid lifters and tbi roller cam. The cam is set to tdc as well as the crank. The car runs alright but it seems to me the valves almost float or stick open because the car doesn't accelerate like it should, it seems to be fighting itself. Also when...
  4. Engine Mgmt., Fuel, Spark, EGTs, & Air/Fuel Ratios
    alright I just wanted to know what are the differences between the say 1989 2.2 t1 cam and the 1989 2.5 t1 cam? I'm gonna put the f-2 cam in my 1989 2.5 (that I converted to a t-II) from fwd performance. would I need a cam gear and If I did what would be the degree I set it on or whatever you do...
1-4 of 4 Results
Top