Turbo Dodge Forums banner
coolant
1-10 of 10 Results
  1. Engine - Turbo & Block
    I have a dodge shadow shelby csx-t powered by the Chrysler 2.2 turbo motor. The coolant line that runs from the radiator to the turbo has completely failed, and I've had no success finding a new one. If anyone has a link to a website that sells it, or has one from a parts car that they are...
  2. Parts Wanted
    Looking for the OLD ‘81-85 guy, NO heater hose inlet, bottom rad hose inlet ONLY. P/N 5203714. Thanks
  3. Turbo Dodge Help
    Need HELP! 87 2.2 TBI Auto Aries. Randomly stalls or tries to, typically after engine warm up. Only code has been coolant temp sensor, which I’ve replaced twice now, both new Mopar units. However Does not always set code. Took all the wire loom off to inspect HEP wiring as well as temp...
  4. Engine - Turbo & Block
    so my buddies 89 lebaron GTC w/ the 2.5t has a really bad coolant leak. it literally pours out when filling the radiator w/ the engine off. i reached my hand behind the engine on the pass side under the intake mani, and found the leak on what feels like a cracked plastic insert... it seems to be...
  5. Turbo Dodge Help
    Well i got this Shelby awhile ago and I lost the cam plug going down the interstate lost about 3.5q of oil so i filled it back up but unfortunately it ate a rod bearing up a bit and soon it ate the crank, rods, cam, I shaft so pretty much everything SO i garbed a extra set of rods and a crank...
  6. Mitsubishi V6 engines
    So I Just bought a 92 Daytona 3.0L with a few coolant leaks (waterpump, freeze plugs, and a few hoses). After fixing all of these things I am having heater issues such as once it warms up it blows lukewarm air, but if I turn the heater off for a few minutes and turn it back on it blows nice and...
  7. Engine - Turbo & Block
    I have a 1986 dodge shelby charger. i just did the head gasket about 300 miles ago. everything went smoothly no problems what so ever. the last 300 miles the boost was turned 3 lbs below stock (5psi) i figured run it low boost for like the first 500 miles to be safe? dunno. but today when she...
  8. Turbo III
    took my head off because engine was overheating and oil and coolant were mixing, most likely a blown gasket. Had the head pressure tested and resurfaced. The machine shop said that it wasnt cracked and that when they resurfaced it they took "less then 5 off". Dont really know what that...
  9. Turbo Dodge Help
    ok. so i think this may be a blown head gasket..but id like to get a second oppion first. i dont know if it would make a difference but i added a half of quart to the 4.5 of castrol sythetic edge about a week ago.. 2 days ago it started up and it was knocking a little bit..so i shut it off and...
  10. Engine - Turbo & Block
    I recently bought a Garrett GT 30R Dual BB for my rebuild and need to know if anyone has experience with what specific fittings I need for my turbo?? I am already getting the lines that have the fittings on the other end for my block but I'm not sure about the turbo fittings, sizes, thread, all...
1-10 of 10 Results
Top