Turbo Dodge Forums banner
engine design
1-2 of 2 Results
  1. Chrysler V6 engines
    Trying to figure out what would be a good combo for some stronger internals for the 3.3/3.8 setups. Does any one have the following measurements for pre-2001 3.3/3.8 engines? Piston to Valve Clearance Piston to deck distance It looks like on of these piston/rod combos would work in a 3.8L...
  2. Engine - General, Exhaust & Induction
    OK, here is the deal....I am building a new turbo race engine for the track. The rules state I can make an engine swap only if the new engine is manufactured by the same company as the car. My car is a 83 - 89 Dodge Shelby, so I can install any engine that will fit. Because I already have tons...
1-2 of 2 Results
Top