Turbo Dodge Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. Engine - Turbo & Block
    I recently bought a 89 daytona c/s that had the 2.5t1 right now it has im pretty sure a 2.2 but the problem is it has no vaccuum lines hooked up and I'm not sure what i have to do to figure out the vaccuum diagram and does it matter what calibration i use?
  2. Turbo Dodge Help
    ive got an 86 T1 daytona automatic sometimes it will start and idle normally and take fuel great other times its hard to start and i have to feather the gas to get it going then its fine untill it gets hot then it will randomly shut off and has to sit a few minutes to restart.i have checked...
  3. Mitsubishi V6 engines
    My engine has a rattle coming from the block and squeals a bit between gear changes which leads me to think the timing belt tensioner is bad or the spring broke. I ordered a new timing belt component kit but as far as I can tell, replacement timing belt tensioner springs aren't sold anywhere...
  4. Turbo Dodge Help
    I have an 89 TC by Maserati with the Turbo II. Great engine but I made the mistake of wanting to fix a vacuum leak which evolved into an entire vacuum replacement. At one point, the car stalled and then wouldn't restart. Codes indicate no signal from hall effect sensor and no signal from fuel...
  5. Engine - General, Exhaust & Induction
    I need some help.... I have an 87 Shelby Z TII, it seems to have a flat spot when accelerating. Here are the symptoms: 1. The power and lights dim then it takes off like a bat outta hell 2. Only really noticable power after 6psi of boost 3. When accelerating it shakes a little bit, but that's...
1-5 of 5 Results