hey guys I am working on this 85 laser.
I have replaced; fuel pump,filter,injectors,plugs,wires,cap,bug.
the prob I have is when I try to take off with a cold engine the car runs fine untill about 2k, then starts to miss like hell. it is so bad that the car will not pull its self. I can do...
Sorry if this is the wrong section for this, and I hate to make yet another thread like this... but I need the help from the gurus on getting this build going.
87 daytona with complete 88 wiring (engine and dash) upgrade)
89 2.5L CB with all the T2 fixins
Engine just dropped in...
87 Dodge Daytona Shelby Z
15" Vacuum at Idle
Timing marks line up, although I didn't check position of distributor rotor
Vacuum lines have been replaced
Fuel pressure and regulator ok
HEP replaced (Mopar)
FWD Performance Stage 3 Calibration
New distributor cap, rotor and...
When you replace your HEP, do yourself a favor and do the following:
1) Pull the distributor
2) Check the shutter wheel to make sure it is not loose
3) Check the shaft for play
4) Set your HEP on the distributor and spin it by hand to make sure that the shutter is not hitting the HEP