no spark

I have a 1989 chrysler lebaron gtc 2.5L TII motor just rebuilt the car has been sitting for the past year and a half so here is the problem...the car cranks but it will not start i am getting code 42 (ASD or fuel pump)the ASD doesnt triger but car runs when ASD is manualy activated i used a...

:eek: The LeBaron came home on the hook last night after stranding me outside of town. Here's the story: It's an 88 2.2 T1 automatic car that is completely stock and has 78K miles on the clock. Up to this point it's been completely reliable although what seemed a bit anemic and displays...

i am a newb and did read some of the other posts and the sticky about this issue but wanted to post anyway with the exact situation. the head gasket finally went and thats when the start spark problem started. i replaced the plugs, wires, cap and rotor but still nothing. i did read somewhere...

I have an 86 Omni GLHT and it wont start the timing is good and there is fuel. I think the +40 injectors are putting out the spark... Is this possible?

here's a new question for you from the "noo b" ...okay, my engine cranks over but no fire. i turn on the ign. switch NO check engine light. checking the wiring i have no 8v ref. for the coil. before i shell out $250 on a new ecu...IS this my problem? i've changed the coil, new hep unit, checked...

i just got a 86 daytona a couple days ago that didn't run but turned over. it is not getting spark and low fuel pressure. not a single vacuum line was hooked up but i hooked up map and fuel regulator. thought it was the asd relay, i read a trick 2 bypass it by hooking a wire 2 the + of coil and...

like it says i finally got it running. started it off and on all damn day! drive it 500 feet and while shifting into third the damn thing just shuts off. its not getting spark from the coil and ive tried mutliple coils to be sure it wasnt a dead one. but tracing it back from there is where i get...

my friend has a low mileage 85 600 turbo(26,000 miles) he drove the car home,got it in the next morning and no start.it cranks,fuel pump primes but no spark.checked codes and getting code 43,problem in power module to logic module interface.any ideas? things he replaced already:hep,both...

hi everyone,well what was supposed to be a simple valve cover gasket replacment turned into a timing belt replacement also when I discovered it in bad shape .I did everything right replacing the belt,but when I tried to start it last night,i got nothing,no spark,no power loss lamp.I waited...

Been trying to get this R/T running that sat since 2000. Compression is a little low all across, but even. Figure it will come back up after it's started and ran a little. Main problem is no spark on cylinders 2 and 3. Swapped to a new coil I had, and same issue. What do I do next?:confused: