Turbo Dodge Forums banner

rings

  1. new pistons and rings

    New Member Intros
    Hi, I have an 89 Daytona Shelby with I believe a 2.2 T2. So, that reminds me, how do I figure out exactly what type of engine and setup it is? The reason for this post is I am not sure what type/brand of parts I need and should go with for this project. I recently found out that I have cracked...
  2. please help identification problem

    Turbo Dodge Help
    i boight the car with just the block in with pistons and bottom end run just a lil though supposibly only 300 on the block brandnew head in the back thinks its a tII head has a turbosunlesed garret and one piece intake i was told it had a 2.2 tII head and 2.5 bottomend well he rebuilt motor...
  3. Good price for pistons + rings?

    Mitsubishi V6 engines
    70.99 for diamante pistons and rings. Beck Arnley Piston And Ring Assembly - Standard - JCWhitney Too bad there's no overbore the ones on importperformanceparts.net cost double but they offer overbore. Which brand would you get? I'm staying n/a if that helps.
  4. Burning Oil

    Engine - General, Exhaust & Induction
    I am the owner of an 85 Shelby Charger. It burns oil and the crankcase is being pressurized excessively. My best guess is that either I have a bad ring or valve guides. I would rather only have to take the head of than pull the entire engine. If that is the case, is there a reasonable way to...
  5. Engine How To: In-car ring change procedure

    FAQ Section
    In-car ring change procedure Requires use of http://www.turbododge.com/forums/showthread.php?t=93575 Well I fully intended to start on a staged boost control rig I planned for the Daytona after I finished the write-up on changing mains. Sadly, I'm having a hard time finding the motivation to...
Top