Turbo Dodge Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. Parts For Sale
    I have a brand new never on the car TU 3" Swingvalve for sale. The TU 3" swingvalve provides 78% more exhaust flow area over the factory Garrett 2.25" Swingvalve and 44% more exhaust flow area over the 2.25" swingvalves used on turbo vehicles after '89. Dyno results have proven an additional 5...
  2. Engine - Turbo & Block
    Is this the correct wastegate swingvalve for my T2 turbo? Swingvalve For Internal Wastegate 5 Bolt to 4 Bolt Discharge : atpturbo.com :fingersx:
  3. Engine - General, Exhaust & Induction
    Ok so I have looked high and low in forums for info on the following question and found nothing. 1985 T1 2.2 Daytona. If I change to a 2.5" or 3" exhaust system what is the deal with the swing valve and waste gate. What size are they stock do they have to be changed to go to a bigger exhaust...
  4. Parts For Sale
    I currently have a mitsu's turbo for sale. No shaft play, never had a problem with it. I was running it at 15 pounds boost. Comes every thing in the pic including the rubber lines, wastegate actuator, swing valve, and the turbo. Will be shipped without the 90 deg. brass fittings. Asking $40...
  5. Turbo Dodge Help
    Some of the ways to prevent your wastegate actuator arm from becoming disconnected from the swing valve; 1)....Go to napa and get a replacement E clip not a C. Part # is 7/32 E clip. 2)....Some folks on here tyewrap them together. 3)....Some have used SAFETY-WIRE to wrap around it...
1-5 of 5 Results