Turbo Dodge Forums banner
tps
21-26 of 26 Results
  1. Turbo Dodge Help
    Got an 89 CSX. Rebuilt the engine, put everything back, changed map, baro, tps, o2, injectors, vacum lines ect... Generally cleaned everything up and renewed some important items. New turbo as well. This thing throws a map code 13, baro read 61 (I think) then a throttle volt code 24, then an o2...
  2. Engine Mgmt., Fuel, Spark, EGTs, & Air/Fuel Ratios
    ok im done for the day, injectors still being cut out by the computer after it starts once and stalls . cleared codes and code 24 presists.. would the tps being over 4.6V cause the computer to turn off the injectors until key off
  3. Engine - General, Exhaust & Induction
    i have used 2 different known good TPS. still keeps kicking it. i have the T2 overlay harness from FM so im only to assume its wired right.could i be installing them wrong? i got her to boost up to around 14 psi for the first time 2nd gear, huge grin ear to ear, then the damn TPS again. any...
  4. Engine Mgmt., Fuel, Spark, EGTs, & Air/Fuel Ratios
    I put in a new AIS unit yesterday and started getting a TPS error code. Why? Also, I started getting wild temp gauge fluctuations!? :confused:
  5. Carburetted and TBI Injected
    Hi All, I have an 1986 Dodge 600 TBI and it has a code for the Throttle Position Sensor and has a very high idle. Does anybody know if the sensor is easy to do? Or does the whole TBI need to come off to do this. Should I clean the IAC while i'm in there? Any hepl would be great. Thanks...
  6. Turbo Dodge Help
    Got a hard Power Loss light upon immediate start after driving car a few hours earlier (car been sitting for 6 hours between). Code 24 TPS. I checked the following when I got the car home. I get 4.94v (5) on the middle wire. This implies that that wire is OK between harness/sensor and LM...
21-26 of 26 Results
Top