Turbo Dodge Forums banner
waste gate
1-6 of 6 Results
  1. Turbo Dodge Help
    So I pretty much just bought an 86 Daytona turbo Z, and all ive done to it is work on it. I've replaced Vacuum lines and the head gasket, and other stuff as well. the car has an upgraded ECU as well. I put 1000 miles on the car and it ran fine. then one day i really matted it and got it up to...
  2. Engine - Turbo & Block
    I am in the middle of converting my 1987 t1 log shadow to t2 status, and after rotating the compressor housing and making an adapter to get rid of the 90 degree elbow on the inlet, and moving the waste gate far enough from intake so it will not hit, my waste gate actuator rod is almost 1/2"...
  3. Turbo Dodge Help
    hi guys i have a 1987 shelby charger T1 with a mitsu turbo im confused which vacuum diagram i should be looking at to plumb in the wastegate the 87 one says to run vac to the solenoid and then the line to the wastegate, but ive been reading thats for a garrett? should i be looking at an 88? it...
  4. Turbo Dodge Help
    okay so i got my van, got an inter cooler setup,bov,boost controller and boost gauge for it,installed everything at once,come to find out i have no boost and was never making boost since i owned the car(couple months now), when i did the install i also took the liberty of removing the valve...
  5. Turbo Dodge Help
    Ok, Just changed from Garrett to Mitsu (dont hate on me, I got it for $60). Installed a vacuum block upon installation. I am getting 0 boost. No smoke and car seems to run fine, just no turbo. I checked the turbine before i put it in. It was tight, no shaft play. Any ideas please? The engine did...
  6. Turbo Dodge Help
    Ok, I was driving my spirit 2.5 turbo earlier. It was running GREAT, took off like a friggin rocket ship. I did a pull on the freeway with my buddy, got off freeway, now i dont get more than 8lbs of boost. ?? I hit maybe 17-18 on the freeway, i figured i may have sprung a leak, so far no...
1-6 of 6 Results
Top