Turbo Dodge Forums banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. Mitsubishi V6 engines
    hello all again from Argentina, i'm asking... which wire i have to buy for connect my car to my pc to scan it? and where i have to connect it.. MUCHAS GRACIAS! (tks)
  2. Turbo Dodge Help
    Ok so this is kinda a dumb question but I need to ask it anyhow. I just replaced the heater core in my 89' Daytona and I'm currently stuck on the re-assembly process due to this wire. It's the manual lever that uses the wire instead of being vacuum controlled. No matter which way I try and run...
  3. Engine - General, Exhaust & Induction
    hi everyone. i have a 86 dodge charger im coverting the 1 wire 02 to a 4 wire. I only have 1 question. i know you hook the heater wire to a 12v source. I heard you use the ignition wire? is that true? and where is the best spot to tap into it? thks! -ryan
  4. Engine - General, Exhaust & Induction
    im going to buy a turbo 2 4 wire 02 sensor for my 86 charger soon. i already know where im putting the 2 ground wires.. but whats a good wire to tap into for the 12v powerwire? thks -ryan:dancing:
  5. Engine Mgmt., Fuel, Spark, EGTs, & Air/Fuel Ratios
    hi there i have a 86 shelby charger. i was wondering where is the best place to tap into the for the 12v wire on the sensor. i was thinking of just going off the 12v tapedeck acc. wire. is there a better 1 tho? also off subject but for the bov..how do u close off the wastegate to install the bov...
1-5 of 5 Results