Turbo Dodge Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
709 Posts
Discussion Starter · #1 ·
does anyone have the 3" bent piece that goes over the axle of a shadow? i have 3" but it dumps out the side. i dont want to have to buy a whole kit just for that axle piece. or at least just dementions of it? i think its a 6" or 6.5" offset right?
 

·
Registered
Joined
·
709 Posts
Discussion Starter · #3 ·
im looking at the factory piece that goes over the axle. its an s-bend. if you lay it on thwe floor, from where the inlet is its offset about 6 or 6.5 inches to where the outlet is. idk if thats making any sense lol i'll draw something...


 

·
Registered
Joined
·
709 Posts
Discussion Starter · #5 ·
oh wow! thats a lot to add... i went to a shop near me today.. he's gonna bend it for me wed. and just bend 2 - 45 degree bends in the pipe and i'll just cut in the middle of em and make it work. it looks tobe a pretty simple bend to get it to fit over the axle, but im pretty sure its gonna turn out to be a PIA... we'll see this weekend i guess. i want to have the full 3" system done by monday so i can make it to Mark's auto show.
 
1 - 5 of 5 Posts
Top