Turbo Dodge Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Does anybody have a link to swapping out the pins on these? I believe both harnesses have to be chopped and rewired together because the Omni has a 40 pin connector and the Daytona has a 50 pin. I haven't verified this for sure yet but any information would be appreciated. This is keeping my swap rather stagnant as I am not very good with understanding wiring. Thanks group!
 

·
Registered
Joined
·
2,211 Posts
WELCOME!!

1988 Omni TBI dash harness should be 50 pin.

1989 Turbo minivan plugs directly in if you could find one.

Minor headlight socket changes needed.

Otherwise chop and splice or add the necessary underhood wiring.

I'm not a wiring/electronics expert but it's very straightforward.

Engine connections and SMEC wiring from the Daytona are basically self contained.

Most colors matched up as I remember

I'll try and find the wiring diagrams I had copied.

GOOD LUCK!

Thanks
Randy
 
1 - 2 of 2 Posts
Top