Turbo Dodge Forums banner
1 - 4 of 4 Posts

· Registered
Joined
·
263 Posts
Discussion Starter · #1 ·
I've got a wrecked 1988 dodge aires w/T1 and am looking to get a 94 shadow w/busted 3.0L (at scrap prices mind u) to put my engine in. if I plug the connector behind the left strut tower into the 94 shadow's plug (assuming it does???) will anything in the car go apesh*t? Basically I'm asking for a better idea of what I'm getting into and if an 89 computer dislikes seeing a 94 body computer.
Is it easier to overcome problems inherent in doing this or to simply go to the junkyard and gut the dash of an 88 shadow?
 

· Registered
Joined
·
263 Posts
Discussion Starter · #4 ·
if I could gut the in car wiring from an 88 or 89 shadow and put them in the 94 car would everything wire up, or should I go on ahead and pull the dash from a junkyard shadow too? I wish I could use the wiring harness from my wagon, but I can't see it fitting. :(
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top