Turbo Dodge Forums banner
1 - 2 of 2 Posts

396 Posts
Discussion Starter · #1 ·
Just got my FWD performance f3 cam kit in the mail today. My car is out of commission due to my S60 cam finally COMPLETELY giving up the ghost (so worn out it was tossing followers like mad)

My question is...

This kit came with lifters, followers, a cam and a few washers. I understand the washers are probably to shim up the valvetrain being that this cam is a regrind. Where should I put the washers? Guessing under the lifters in the bore but i wanted to make sure.

Tried calling Cindy but it was after thier hours by the time I got off work. :bash:

1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.