Turbo Dodge Forums banner
1 - 4 of 4 Posts

· Old School Hot Rodder
Joined
·
1,753 Posts
I believe you need this one:
Wheel Automotive tire Alloy wheel Hubcap Rim
Toy Art Wheel Gas Jewellery

I have a spare I think, but the tubular "pins" are not serviced nor have I found a replacement.
 

· Old School Hot Rodder
Joined
·
1,753 Posts
You were asking about the boost gauge, I take it the rectangular plugs are what you currently have? So what is in the location where the boost gauge will go?
Here is mine, in a 1989 J dash:
Motor vehicle Gauge Vehicle Vehicle audio Measuring instrument
 

· Old School Hot Rodder
Joined
·
1,753 Posts
So you need what wire goes to what pin on the boost gauge/information center. They use door jamb switches at the back edge of the doors for the door ajar warning.
Here they are, the wiring is the same, other than the two extra lights in the boost gauge. M13 is right door ajar, M3 is left, I used M4 for my trunk ajar warning since the diagrams are from a G body, so it says "liftgate".
 

Attachments

· Old School Hot Rodder
Joined
·
1,753 Posts
The car is a 1989 J or G body if I read everything correctly. I assume what you have there is a vehicle information center. I will need to go get my 1989 electrical volume most likely. I believe what you have is called an "electronic monitor" and AllData only shows with and without it, no actual connectors.
 
1 - 4 of 4 Posts
Top