Turbo Dodge Forums banner
1 - 4 of 4 Posts

· Registered
Joined
·
1,134 Posts
Discussion Starter · #1 ·
89 Lebaron coupe.
There was a plate at the top of the dash with a boost gauge I wanted to go back to the stock looking boost gauge but the round plug is not there for some reason...
Gas Circuit component Tints and shades Electrical wiring Technology

Do I need this type?
Speedometer Vehicle Plant Trip computer Tachometer
 

· Registered
Joined
·
1,134 Posts
Discussion Starter · #5 ·
You were asking about the boost gauge, I take it the rectangular plugs are what you currently have? So what is in the location where the boost gauge will go?
Here is mine, in a 1989 J dash:
View attachment 283189
It's a black plate with a VDO boost gauge. I want to return it to stock boost/information center. I have a pile of the ones you have but there's no plug to hook it up.
 

· Registered
Joined
·
1,134 Posts
Discussion Starter · #7 ·
So you need what wire goes to what pin on the boost gauge/information center. They use door jamb switches at the back edge of the doors for the door ajar warning.
Here they are, the wiring is the same, other than the two extra lights in the boost gauge. M13 is right door ajar, M3 is left, I used M4 for my trunk ajar warning since the diagrams are from a G body, so it says "liftgate".
Do you think those wires are on those 2 rectangular plugs? Or should I seek out the other information center?
 
1 - 4 of 4 Posts
Top