[88shadowpjct]

i found one that im gonna have to use... how can i test it with my multimeter to see if it's the 0.8 ohm that i need for the msd? does it go in-line or just attatch to the (+) side and just bolt to the body?

 

[88shadowpjct]

im pretty sure its a factory one.. there is a small cylinder with one wire comming out and a hole to mount the cylinder. is this a factory one or no?

 

[88shadowpjct]

i can't post pics..

it's an MSD blaster 3 coil. in the paperwork it says

"NOTE: This Blaster Coil Kit is intended to be used with an MSD ignition. If installed on a stock, points style ignition system, a 0.8 ohm ballast resistor or resistor wiring MUST be installed. MSD offers this Ballast Resistor as PN 8214 or the Blaster Coil Kits, PN 8202 and 8223 are equipped with one.

WARNING: Failure to use a ballast resistor could result in personal injury or component failure."


what is the "MSD Ignition system" can i do this or no?

 

[88shadowpjct]

ok so, mount this resistor, run the + wire to one end then from the other end go to the coil?