Turbo Dodge Forums banner
1 - 8 of 8 Posts

· Registered
Joined
·
1,556 Posts
Discussion Starter · #1 ·
so im swapping engines in my omni. going from stock t1 to a 87-88 t1 block. using ported swirl head. the head gasket was brand new and the head bolts also. do i need to replace them again? i mean they don't even have an hour of run time on them. feed back always appreciated:thumb:
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top