Turbo Dodge Forums banner
Status
Not open for further replies.
1 - 15 of 15 Posts

· Registered
Joined
·
109 Posts
Discussion Starter · #1 ·
I finally started my car that ive been working on since last summer (you might remember seeing pics on here) it fired right up and sounds so good, still need to install the turbo but i need a couple of things to do that let me know what you think


 

· Registered
Joined
·
1,151 Posts
Nice setup! Whats the run down on spec that you will be running?

Did you use the header from a grand prix and cut it up, looks like the GP header to me.

You should dump that 52mm and toss on a 58-60mm TB, lots better!
 

· Registered
Joined
·
109 Posts
Discussion Starter · #3 ·
thanks, im running stock lower end stuff just been bored 30 over and completly rebuilt. ported heads, lower and upper plenum ported,52mm throttle body, billet fuel rails, half inch intake spacers. cheap ebay turbo for now(until i get my gt35r) srt4 intercooler,2.5 in full custom mandrel bent exhaust. the intake spacers and the header flages were cut (water jet or laser cut) by me. I built the headers from scratch. I basicaly wanted to build a fun every day driver.
 

· Registered
Joined
·
5,790 Posts
I must say that is a unique way of test running an engine that's supposed to have a turbo, but the turbo isn't installed completely yet!

I hope you're running a pusher fan on that radiator.

Other than that...looks like it'll work! Good luck! :thumb:
 

· Registered
Joined
·
4,660 Posts
some fine rice cooker you got there! Set it to "burn" :thumb:
 
1 - 15 of 15 Posts
Status
Not open for further replies.
Top