Turbo Dodge Forums banner
1 - 4 of 4 Posts

·
Registered
1989 Daytona Shelby 2.2 TII
Joined
·
320 Posts
Discussion Starter · #1 ·
I have a Vac Block I ordered off Ebay. The barbed fittings are 1/8". My question is, is the 1/8" hole in the barbed fittings standard for most Vacuum blocks? I notice most blocks come with 1/8" fittings, so I wasn't sure. I ask because, is it worth getting fittings that have a 1/4" hole rather than 1/8" (less restrictive) or is it not worth the effort?
Musical instrument Musical instrument accessory Electronic instrument Rim Electric blue
 

·
Administrator
Joined
·
25,639 Posts
My vacuum block has the same fittings and I used them with no issues, the ID of original factory vacuum harness was not any larger.

Car Vehicle Motor vehicle Automotive fuel system Automotive air manifold
 
1 - 4 of 4 Posts
Top