Turbo Dodge Forums banner

1 - 15 of 15 Posts

·
Registered
Joined
·
1,106 Posts
Discussion Starter #1 (Edited)
For Sale, freshly resized rods that were going in my built 2.5L Omni. I have upped my HP goal so these are up for grabs. These were just resized and cleaned, and have new ARP wave lok bolts installed. The motor was assembled with these but not installed/run. They are bushed for a larger .912" pin commonly used with FWD Performance spec Venolia pistons.

EDIT: $200 shipped in the US
 

Attachments

·
Registered
Joined
·
1,106 Posts
Discussion Starter #8
Mike, what did you swap to to hold up to your HP goal and what is the new goal?
I want the rods to be able to support 600+ ft/lbs of torque. We are going to turn this little 2.5 up. These t2 rods would have probably fine but just in case I get boost happy I don't want to take it apart again.
 

·
Registered
Joined
·
11 Posts
For Sale, freshly resized rods that were going in my built 2.5L Omni. I have upped my HP goal so these are up for grabs. These were just resized and cleaned, and have new ARP wave lok bolts installed. The motor was assembled with these but not installed/run. They are bushed for a larger .912" pin commonly used with FWD Performance spec Venolia pistons.

EDIT: $200 shipped in the US
Hey do u still have these pistons
 
1 - 15 of 15 Posts
Top