Turbo Dodge Forums banner
1 - 1 of 1 Posts

·
Registered
1986 Omni GLHT
Joined
·
7 Posts
Discussion Starter · #1 ·
I pulled my fuel rail, and the rubber tip of injector 4 separated from the rest of the injector. I heard something bouncing down into the engine bay, so I'm pretty sure it's gone forever. I found the I rings at least. It might still be in the hole though, I need to shine a light in and see. Pic attached, good injector on the left, broken one on the right, metal is visible, along with the needle. Would I be able to replace it with just the tip of a new injector, or do I have to get a whole new flow matched set? I've been planning on upgrading to turbo II with the (+40% if I remember correctly) injectors eventually, but I don't think I can add them on their own without doing the whole turbo II package, right? Any advice would be appreciated.
Motor vehicle Automotive tire Automotive exterior Automotive wheel system Gas
 
1 - 1 of 1 Posts
Top