Turbo Dodge Forums banner
1 - 20 of 21 Posts

· Registered
Joined
·
449 Posts
Discussion Starter · #1 ·
going for 400 whp looking for parts sugjestions its gonna be an 8 valver in a lbody

555 trans or 568 whatever someone sells me
lsd moly plate
rev loc clutch
tu rods
weisco pistons
cast crank
posibly 4 bolt mains
ported head with bigger valves
tu hybrid header
s70 turbo
spearco intercooler
+40s 255lph pump
either 2 peice ported intake or custom sheetmetal not sure
custom smec cal
see any problems with this making 400 whp

any other ideas welcome
 

· Registered
Joined
·
449 Posts
Discussion Starter · #11 ·
400 whp is not easy to get on a 8V, everything must be done perfect and the cal is VERY important. You need to control your AF,timing and monitor Af and Knock.
Trying to jump step usaualy cost a rebuild
which is why i will have help with the cal. mostly seeing if all the parts i want to buy will take it then build it then tune it kinda thing i guess
 

· Registered
Joined
·
449 Posts
Discussion Starter · #13 ·
- 3 inch exhaust system
- I have see you have a 86 SC you need a commun bloc
- a FWD trim cal can be a solution for you..easy tuning on the fly.
- Innovate LM-1 Wideband + rpm converter for logging.
-$

yeah i left all that out because i know i need that stuff got a common block motor and innovative is the shit so i was gonna run that and do they sell an rpm converter? i just left that out cause thats kind of obvious i guess

tell me more about the the trim cals
 

· Registered
Joined
·
2,468 Posts
May want to add a neon dohc cylinder head conversion to your recipe.
 
1 - 20 of 21 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top