Turbo Dodge Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
2,839 Posts
Go with what ARP recommends and not what several folks say (lol). I see you're using the 241-4701 12 point kit. Good choice! I once found using the 241-4501 kit (six point hex bolts), that they hit the valve cover in the corners when valve cover was installed. Wonder if that contributed to numerous people that seem to snap off corners on their valve covers?
Careful if ever using ARP head BOLTS. Nice bolts, but they were made too long! They bottom out in cylinder head before they torque up to spec., unless you use two washers or run a bottoming tap on the block.
Wood Tool Font Office ruler Handwriting
 
1 - 1 of 1 Posts
Top