Turbo Dodge Forums banner
1 - 9 of 9 Posts

·
Registered
Joined
·
44 Posts
Discussion Starter · #1 ·
GONNA TAKE OFFERS FOR PARTING IT OUT OR SELLING WHOLE. HATE TO DO THIS TO MY BABY. WILL ALSO DO PARTIAL TRADES FOR CONQUEST OR 2DR NEON. THX

i am selling my 88 turbo minivan-very relucyantly! in over all very good condition. lots and lots of mods done.
2.5 turbo motor w/balance shafts removed
bottom end has been refreshed:
speed pro rings
clevite bearings
mellings hi flow oil pump
race ported head w/stock valves
custom built:
sheet metal intake manifold
spearco water to air intercooler
fuel rail - has a stock rail on it now cuz i used external fuel reg
on another car
turbonetics external wastegate
ported exhaust manifold
brand new .60 ar t3 turbo
greddy blow off valve

trans is new and built:
turbo action reverse manual valve body
fwd 3500 rpm stall
kevlar clutches
kosei k1 light weight race wheels 15in
battery was moved to rad support
all seems fully welded as were motor mounts
1x2 in box tubing was added to lower rad support and tied to frame rails
does needs some stuff buttoned up to finish her up right. i dont have time nor the funds right now. i really hate to see it go. lots n lots of money and time tied up in it. asking $4000.00 may take partial trade
I made all these parts myself, so if you need something made let me know i may be able to help.
http://www.geocities.com/iron_murt/van14.jpg
http://www.geocities.com/iron_murt/van9.jpg
http://www.geocities.com/iron_murt/van1.jpg
http://www.geocities.com/iron_murt/van10.jpg
http://www.geocities.com/iron_murt/van13.jpg
http://www.geocities.com/iron_murt/van3.jpg
http://www.geocities.com/iron_murt/van4.jpg
http://www.geocities.com/iron_murt/van6.jpg
http://us.share.geocities.com/iron_murt/van7.jpg
http://www.geocities.com/iron_murt/van8.jpg

email me with question or for more pics
[email protected]
 

·
Registered
Joined
·
44 Posts
Discussion Starter · #5 ·
Runs good. motor mounts are solid so as long as you dont mind your teeth rattling :) it would make a good driver.
taking offers for parts, then will decide if i am gonna part out
 

·
Registered
Joined
·
145 Posts
88 non common block?? did you cut the crank?? compression test??
did you resize the rods?? was the block bored/decked etc?? hone plate?? pistons matched to block etc.. yada yada
burn any oil? smoke or knock??? id be interested in the motor as a whol if the price was right like as much information you could provide would be great.

pm me if applicable.
 

·
Registered
Joined
·
44 Posts
Discussion Starter · #9 ·
motor is 88 2.5 w/stock rods. nothing was turned. only needed a slight hone in bores. head was milled .30 if i am not mistaked-ported n polished. was on my wifes race motor. motor really aint even broke in. 0 miles on it. taking offers right now, to see if it is worth parting out. would rather sell it whole. lots of time went in to her
 
1 - 9 of 9 Posts
Top