Turbo Dodge Forums banner
1 - 3 of 3 Posts

· Registered
Joined
·
329 Posts
Discussion Starter · #1 ·
I am about ready to pop these back in the tail panel of my GLH. I have purchased butyl to seal these to the tail panel but my question is concerning the 4 clips on each of the taillight panel/lenses. Do I install the clips before I slip them into place OR do I put them on after ??? Thanks for your help!
 

· Registered
Joined
·
329 Posts
Discussion Starter · #2 ·
It is a delicate balance of butyl thickness to clip engagement. I installed the clips on the light assemblies and applied the butyl around the corresponding "contact face" and pushed them into place. I also filled the top gap of the lense to the body to channel water away from any potential leak points into the trunk. Turned out really nice. It's amazing that Mopar used this method but it seems to work considering the 100's of thousands Omni/Horizons made. As an aside, I removed the 1/8" metallic silver border on each lense.....gives a cleaner look in my opinion.
Automotive parking light Automotive tail & brake light Vehicle Car Vehicle registration plate
 
1 - 3 of 3 Posts
Top