Turbo Dodge Forums banner
1 - 1 of 1 Posts

· Registered
Joined
·
4,833 Posts
Actually, the Non-CB bracket will work on a CB bracket for the PS pump. I had a non-CB bracket on the 91 block that was in my 83 Rampage. But it is pretty much a straight swap if you are looking to keep the same setup. But as 4Daytonas said, if you are looking into upgrading wiring, then you will want to look at the sticky in the Electrical section that shows you how to swap the T1 harness to a T2 status. But all is very simple, heck you could probably find a T2 harness for the car from an 88+ Lancer/Lebaron GTS.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top