[crashmydaytona]

I am pulling my daytona engine for a rebuild, im not sure how to seperate the tranny from the block i have never worked on these type of motors. On others i have found windows or plugs that give you access to the last few bolts. What is the best way to do this on the 2.5 thanks for the help

 

[turbokid]

is it an automatic or 5 speed. 5 speed is a little easier cause the bellhousing bolts are all that need to come out correct??? I have pulled the motor on my auto baron and the bellhousing bolts and the torque converter bolts also need to come out. Its really not that hard.

 

[speeduphoria]

many people say taking the motor and trans together out the bottom is easiest

 

[crashmydaytona]

it is an automtic and it is the torqe converter bolts holding it together. do you access them through the starter.

 

[kermit]

Is it an auto? Did you pull the starter?

 

[kermit]

it is an automtic and it is the torqe converter bolts holding it together. do you access them through the starter.

I think you can get to them through the access panel on the bottom of the trans.

 

[speeduphoria]

I think you can get to them through the access panel on the bottom of the trans.

yes, there is a thin plate its 2 pieces the bottom part comes off so you can rotate the converter to access one bolt at a time

 

[crashmydaytona]

Thanks for the help. Got it pulled last night