Turbo Dodge Forums banner
1 - 1 of 4 Posts

· Registered
3,910 Posts
All of the mounts?

Passenger and front mounts will need the engines weight taken off of them. Jack ... whatever. Pay attention to rubber orientation.
Bobble strut on the trans (if you have one) isn't a big issue. If you're replacing it with a solid mount don't preload it too much. Just get a little weight on it.

Trans mount (driver side) is tougher. Engine needs tilting down on this side to get the bolts. (bobble strut and front mount thru bolt should be out to make this maneuver easier) There are three on the trans and one on the frame rail. Get a jack under the trans and car on blocks. Remove tire then the frame rail bolt. Lower drive train enough to access the three other bolts.
1 - 1 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.