Turbo Dodge Forums banner
1 - 7 of 7 Posts

·
Registered
Joined
·
1,008 Posts
Discussion Starter · #1 ·
I just called Turbonetics, and they're being nothing but a pain. I have one of their older turbine housings, part number 20359, that I cannot identify. On their list, that part number designates a .82 A/R housing, yet on the inlet, it says ".48". Which stamping is wrong? I measured as best as I could to find the A/R, and I came up with about .57, based on eyeballing, paper, calipers, and tape.

My request is this.. PLEASE post ANY pictures you have of the inlet side of your T3 turbine housings. I'm looking to compare this housing visually to other known sizes (.48 (stock), .63, etc).

I'll start by posting all I have at the moment, a photo from TDG. Thanks guys!!

http://www.thedodgegarage.com/turbo/turbo_housings.jpg
 

·
R.I.P Dennis Jarvis
Joined
·
5,369 Posts
ttt
 

·
Registered
Joined
·
1,008 Posts
Discussion Starter · #5 ·
I'm not able to take pictures right now. Away from home this week.

Anybody have any photos?
 

·
Registered
Joined
·
1,008 Posts
Discussion Starter · #6 ·

·
Registered
Joined
·
1,008 Posts
Discussion Starter · #7 ·
140 views, come on guys :D
 
1 - 7 of 7 Posts
Top