Turbo Dodge Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
63 Posts
Discussion Starter · #1 ·
so i resoldered the joints before i got my car running. that was a few months ago. Now its running and i was driving it today and i floored it and the tach went up to about 2500 and stopped going up. It works at below that but not any higher. Should i reflow the joints on the back of my tach and hope it fixes it. Thanks
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top