Turbo Dodge Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
1,638 Posts
Discussion Starter · #1 ·
i had ebay neon short shifter for couple years now, it has always been very tight , as in tight on the ball in the shifter housing, any one have this problem ?i assume the ball is just too big for the housing,


im gona cut it apart this week anyways and cut a inch off top and add it in on the bottom, via instructions on this site
 

·
Registered
Joined
·
1,152 Posts
Was the shifter from autodynasty? I tried to order one but they stopped selling them due to a design issue and sent my money back, could of been from the same manufacturer.

The Stock shifter ball can be moved up and down so you could just slide the ball up a inch then cut another inch off the top, then add a inch all around the base for the shifter to drop down.

On a side note, I bought a used fidanza short shifter and it fits in the housing fine just like factory. Too bad they only cut the top off and don't lengthen the rod at the bottom.
 
1 - 2 of 2 Posts
Top