Turbo Dodge Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Looking for a Coolant Return Line for a Turbo II (87-90 Daytona Shelby) The part # is 4448697

Thanks
 

·
Administrator
Joined
·
3,988 Posts
Looking for a Coolant Return Line for a Turbo II (87-90 Daytona Shelby) The part # is 4448697

Thanks
Where are you located in Canada?

It is increasing difficult to find these lines not rotten. If originality isn't an issue, take an existing unit to a hydraulic shop and they can make a superior version for around $50.

Turbododge vendors also sell the full line sets in stainless, but you must buy the entire set USD$110 (+shipping, customs, exchange rate - yuk)
 

·
Registered
Joined
·
2 Posts
Discussion Starter #3
I'm located in Toronto. I'm doing a TI to TII conversion, upgraded to a 89-90 TII Turbo, but I notice my original line do not fit. My preference is original hard line if I can locate one. I have looked into the braided line by TurbosUnleashed. Yeah they are expensive, but it may be my only option left if I don't have any luck here.
 
1 - 4 of 4 Posts
Top