Turbo Dodge Forums banner
1 - 4 of 4 Posts

· Registered
Joined
·
782 Posts
Discussion Starter · #1 ·
contact me if you have these or can make these for me.

also looking for a 3 bar, underdrive pulley for an 89, +40% injectors, 2 piece fuel rail,

i also have stuff to trade

tii injectors 2 sets
1 piece fuel rail stainless
stainless 1 piece fpr
stainless +20% injectors tested and cleaned
ported 1 piece intake w/ 52 mm t-body
58mm t-body
ported exhaust manifold
a/c delete bracket and pulley
t2 rods
good intermediate shaft
cast crank
to name a few things i have
 

· Registered
Joined
·
2,291 Posts
I have a 2 piece intake fuel rail. 75.00 shipped. can send pic if interested.
 

· Registered
Joined
·
782 Posts
Discussion Starter · #3 ·
i have one, but was looking for an extra, because i was going to try to remove the tube inside and weld it back shut. i can get the tu model for 105.00 new i was just looking for something cheap 25.00 or less in case i mess mine up.
 

· Registered
Joined
·
2,291 Posts
sorry cant let mine go that cheap. to hard to find nice ones that have the whole fuel line intact.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top