Turbo Dodge Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
696 Posts
Discussion Starter · #1 ·
I wanna know what tools do I need to remove a head on a 1983 2.2l non turbo. I removed mine but forgot what sockets I used. I'm asking this because I'm going to a u-pick it junk yard and don't really wanna take all of my tools with me.
 

·
Registered
Joined
·
696 Posts
Discussion Starter · #4 ·


I have 1/2 rachet + mm Socket set, 3/8 rachet + mm socket set, Breaker bar, Cordless Grinder with cut off blade + extra blade, various screw drivers, various plyers, wire brush, safety Goggles, Piece of paper that says Headbolt Removal sequence + casting numbers of heads that fit my omni, About 10 wrenches, Dead blow hammer and various miscellaneous stuff.


I know I went overboard but the yard I'm going to is an hour away from me and there might be something else I need off of the omni in the yard.
 
1 - 4 of 4 Posts
Top