DRB II Help--Making the SCI Cable, Need Pinouts

22300 Views 78 Replies 13 Participants Last post by reedfranklin, Jan 23, 2019

bamman

Discussion Starter · Oct 1, 2011

I recently just purchased a DRB II that was missing the cable to connect to the under hood connector. Miller Specialty Tools reports that the cable, CC2000, is discontinued. Rather than endlessly search for one, I'd much rather build one. I have an extra SCI cable from my Actron 9145 scanner that I can use to assist me in building this cable. All I need now is the pin-outs of cable end of the DRB II. Can anyone help?

Save

1 - 2 of 79 Posts

ecaruci

· #34 · May 22, 2015

bamman said:
Yes I did make the CCD/Airbag cable.

And pin 4 is the light green wire:

Hi! in this drawing pin 1 in one end matches pin 1 in the other end? i mean is a 1 to 1 2 to 2 conection and so on relation?
thanks for replying

Save

ecaruci

· #35 · May 22, 2015

ecaruci said:
Hi! in this drawing pin 1 in one end matches pin 1 in the other end? i mean is a 1 to 1 2 to 2 connection and so on relation?
thanks for replying

Hi again! my DRB II cable is useless i am trying to set a DRB III diagnostic cable which looks similar but has 16 wires instead of 10. Doing more or less guessings on the order i made this cable to power on the DRB 2 scanner but is not retrieving any codes or information from the engine it hangs.

Save

1 - 2 of 79 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month